Results 1 to 9 of 9
  1. #1
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts

    Test Cyp Conversion (Pics)

    Test Cypionate 10 gram conversion

    Needed:
    10 grams Test Cypionate
    Magic Solution
    40ml Sterile Oil
    syringes 3cc & 5/10cc
    2 - 18 or 20 guage needles
    50ml Vial
    50ml Sterile Vial
    whatman sterile filter
    Attached Images Attached Images

  2. #2
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #1
    A. Weigh out 10 grams of powder.
    B. Place powder in vial.
    C. Add 5mls of "Magic Solution" to the vial.
    Attached Images Attached Images

  3. #3
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #2
    Swirl the mix of solution and powder around in the vial.
    A glass stir rod is very good to have for this though it is not nessasary.
    Attached Images Attached Images

  4. #4
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #3
    A. Heat a pan or pot of water just to the point where it starts to boil then pull it off and onto a burner heat is off.

    B. Then place the vial into the water and let it sit for about 10-15 minutes. Give it a swirl and or stir with the glass rod to help it melt in the solution.
    Attached Images Attached Images

  5. #5
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #4
    Add 35mls of oil to the solution. You can use a funnel as shown.

    *** Note: To sterilize the funnel you can wash it well and let it air dry. Then run some Methyl Alcohol through it and let it dry again.
    Attached Images Attached Images

  6. #6
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #5
    You will want to re-heat the water to boiling point again as you will be letting it sit in it again.
    Attached Images Attached Images

  7. #7
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #6
    At this point you can placea stopper on the vial and shake it well. Then place it in the bath of hot water for approx 15 minutes.

    ***Note: it may take some time for it to fully suspend and may look grainy but it will suspend... it just takes a little time.
    Attached Images Attached Images

  8. #8
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #7
    Here you can see it is suspended well and is nice and clear and ready to be filtered.
    Attached Images Attached Images

  9. #9
    Senior Member K1's Avatar
    Join Date
    Aug 2012
    Posts
    455
    Thanks
    0
    Thanked 12 Times in 9 Posts
    Step #8
    This set-up will look familiar to those who have make Fina.

    The set-up is a sterile vial that is vented and the whatmen filter attached to an 18 guage pin.

    You will draw from the vial and then cover the pin and detach it from the syringe. Then re-attach the syringe to the whatman filter that stays attached to the vial.
    Slow and steady you will push the product through the filter using the 10ml. syringe.

    You will do this till all the product is filtered AND keeping track of how many mls you push through.

    You will want to even it out in the end and purge the filter with whatever amount of sterile oil is nessesary to make it 50mls. This will also get all the remaining product flushed out of the filter.

    You final product will be a painless 200mg/ml @ 50mls of Test Cyp.
    Attached Images Attached Images

Similar Threads

  1. Test 500mg/ml Conversion (Pics)
    By K1 in forum Chemical Conversion and Homebrewing
    Replies: 9
    Last Post: 04-14-2013, 04:54 PM
  2. Test Enan Conversion (Pics)
    By K1 in forum Chemical Conversion and Homebrewing
    Replies: 9
    Last Post: 08-28-2012, 08:46 PM
  3. Test Prop Conversion (Pics)
    By K1 in forum Chemical Conversion and Homebrewing
    Replies: 10
    Last Post: 08-28-2012, 07:21 PM
  4. Test Enan Conversion (Pics)
    By K1 in forum Chemical Conversion and Homebrewing
    Replies: 0
    Last Post: 08-28-2012, 04:56 PM
  5. Test Enan Conversion w/ Pics
    By K1 in forum Chemical Conversion and Homebrewing
    Replies: 10
    Last Post: 08-28-2012, 03:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •