Suitcase Style 1-Arm Deadlift...

BrotherIron

Moderator
Joined
Jun 24, 2012
Messages
3,304
Reaction score
5,869
Points
238
Author unknown...

The Suitcase-Style One Arm Deadlift is a powerful, exercise that you will rarely see anybody do. The reasons? First, it's NOT a common exercise, even though it's been around forever. Second, it's a tough exercise to do!

The Suitcase-Style One Arm Deadlift places extreme stress on the core and will help you develop an incredibly tight and powerful midsection. Basically, instead of using both arms and doing a barbell deadlift in front of your body as you normally would, you'll stand BESIDE the barbell and pick it up with one arm.

Imagine reaching down and picking up a suitcase sitting beside you. That's the Suitcase-Style One Arm Deadlift but, of course, using a heavy barbell!

How To Do It:

First, if you're doing this exercise off the floor, load a barbell with a 45-lb plate on either end. To lift this amount of weight, you should be able to deadlift at least 250 to 275 lbs in a conventional deadlift.

Stand beside the barbell and reach down and grasp it with one hand. When you do the One-Arm Deadlift, you should grip the bar slightly off-center. Your thumb and index finger grip should be about a centimeter (about a half inch or so) from the edge of the center grip surface. This uneven grip will prevent the bar being lifted unevenly and tilting as you are lifting.

The reason for this is that when you grip the bar with one hand, your thumb and forefinger grip area become the main pivot point. If that main pivot point is not close to the real center of the bar, the bar will tilt when you pick it up. By sliding your hand down so that your thumb and forefinger grip area is closer to the real center, you will have a much easier time keeping the bar level.

Before you pick up the bar, make sure your shoulders are level and your entire core area is tightened up very strongly. Pick up the bar, focusing on keeping your shoulders level as much as possible. The weight of the bar on the one side will place an EXTREME stabilizing load on the other side of the body. You will be pushing HARD with the same side foot as you're pulling on the bar, e.g. if you're picking the bar up with your right arm, you'll be pushing hard with your right foot.

Keep your lower back tight and arched as you stand up. Come all the way up to the top position and hold for a few seconds then lower the bar back down slowly. Gripping the barbell with one arm in this fashion is also VERY challenging to the grip. You'll need to hold on tight in order to keep your grip on the bar.

Set the bar down on the floor between reps and relax the core. Re-tighten everything then start your next rep. This exercise should only be done for low reps, e.g. 3 to 5 reps per set. Any more than that and the stabilizing muscles of the abs will become fatigued and cause the torque to go into the lower back instead of the abs, where you want it.

The first time you do this exercise, start with a conservative weight. It's deceptively tough, especially if you've not done a lot of movements that are weighted on only one side. The torque on your core will be a very new thing! The incredible tightness you'll feel all along your side abs the next day will show you just how effective this exercise is.

If you're a strong deadlifter or find your grip strength limits the amount of weight or number of reps you can do, I would DEFINITELY recommend grip assistance in the form of either lifting straps. The grip assistance will allow you to use heavier weight and hold onto it longer. It will also prevent the bar from rolling out of your fingers as your grip fatigues.

Give the Suitcase-Style One Arm Deadlift a try in your next back workout. I can promise you'll either be thanking me or cursing me for the next two days after you do it! Your entire core will be worked in a way it has NEVER been worked before.
 

Uncle manny

Elite
Joined
Apr 22, 2015
Messages
1,554
Reaction score
937
Points
113
Great for your core especially emphasizing obliques. I do this a few times a month and the sheep look at me like wtf this guy doing.
 
Joined
Apr 7, 2020
Messages
21
Reaction score
5
Points
0
There’s an Ed Coan video where he would do a part of this from a power rack with iso holds. Mostly for grip so he would only have to lift up like 3-4 inches and then stabilize with obliques. But he would work up to some damn long holds.
 

rawdeal

Elite
Joined
Dec 8, 2018
Messages
1,356
Reaction score
1,613
Points
113
I know BI from the other board, so I'm sure HE knows this, but google Herman Goerner (the spelling varies slightly depending where you read). He was a German strongman whose career was split into pre- and post-WW I.

Not sure if what ol' Herman did was the suitcase style BI describes, think it was more conventional where he faced the BB rather than stood alongside it(?)

Among other things he did a one armed deadlift around 720-730, bodyweight less than 300, and would have had to be natty. Not too shabby on the back strength, but , Holy Shith, imagine the GRIP.
 
Last edited:

So1970

Senior Member
Joined
Dec 3, 2016
Messages
113
Reaction score
32
Points
28
Does this use the barbell more for the balance or would using a heavy dumbbell be as effective. I work on a tugboat and space is limited
 
Joined
Apr 7, 2020
Messages
21
Reaction score
5
Points
0
Barbell is way harder on small stabilizing muscles because of the balancing required. If you do with a heavy dumbbell or kettlebell you’ll still get good work in, but go heavier than you would with the barbell.
 

Sicwun88

Senior Member
Joined
Jan 27, 2020
Messages
2,285
Reaction score
1,149
Points
113
I've have done then many times,.
A good exercise when you're trying to switch things up!
 

Boogieman

Elite
Joined
Aug 20, 2019
Messages
1,343
Reaction score
1,195
Points
113
If you want to change up some lifts, head on over to the USAWA site and read about some of their odd-lifts, hundreds of them...

http://usawa.com/wp-content/uploads/2010/05/RULEBOOK-10th-Edition.pdf

ROT, thanks for that! I found this gem!

THE "Ziegler Clean"

The rules of the Clean apply with this exception. A weight plate, not smaller than a 1 1/4 kilogram plate or a 2 1/2 pound plate, is placed on the head of the lifter prior to the clean. The plate must remain on the lifter’s head during the entire lift. If the plate falls off the head at any time during the lift, it is a disqualification. The plate must not be attached to the lifter’s head in any manner.
 

New Threads

Top