Page 1 of 2 12 LastLast
Results 1 to 20 of 31

Thread: Cloudy GEar :(

  1. #1
    Senior Member
    Join Date
    Nov 2012
    Posts
    128
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Cloudy GEar :(

    I got my package today and only one vial was cloudy. The vial is test c. Im thinking it is cloudy bc it is very cold outside. I tried heating it up with a hair dryer and it went clear but like ten mins later it go cloudy again? Does this mean its not any good? Can i do anything about it?

  2. #2
    Member
    Join Date
    Nov 2012
    Posts
    19
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    I think you have to put it in a pot of hot water/ boiling water ...
    Believe some people throw it in the oven for a lil while

    Deff wait for someone with a lil more experience to chime in think I'm pretty close tho from what I remember

  3. #3
    Senior Member
    Join Date
    Nov 2012
    Posts
    128
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    Im going to put some water in the microwave for a few mins and then stick the vial in the water for around 5 mins. then if that doesnt work im going to back it in the oven at 275 degrees for 1 hour. Hopefully it will work with the bowl of water.

  4. #4
    Member
    Join Date
    Nov 2012
    Posts
    19
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    If you put it in the oven i think you may need to stick a needle into the rubber while heating to allow air to escape and avoid an explosion

  5. #5
    Elite Christosterone's Avatar
    Join Date
    Oct 2012
    Location
    Texas
    Posts
    1,026
    Thanks
    16
    Thanked 16 Times in 16 Posts

    Re: Cloudy GEar :(

    How many Mgs per ml is it?
    All posts are for entertainment purposes only

  6. #6
    Elite PillarofBalance's Avatar
    Join Date
    Feb 2012
    Posts
    20,496
    Thanks
    2,144
    Thanked 18,093 Times in 7,788 Posts

    Re: Cloudy GEar :(

    This isn't a big deal. Just heat and swirl each time before using it.

  7. #7
    Senior Moderator Spongy's Avatar
    Join Date
    Apr 2012
    Posts
    4,503
    Thanks
    498
    Thanked 3,575 Times in 1,617 Posts

    Re: Cloudy GEar :(

    my guess is that it is starting to crash, pretty common this time of year, especially with test C. boil some water, remove from heat, stick vial in water for 20 min.
    In need of dieting help? Email me at HeliosNutrition@gmail.com

    Asking pillar how much orals to take is like asking Charlie Sheen how many hookers you should ****. - Jin

    #mUGga

  8. #8
    Member
    Join Date
    Nov 2012
    Posts
    42
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    These are all good solutions. But what i do is turn my coffee maker on, stick it on the hot plate (after its already hot) for about three minutes. Your gear is fine. If it crashes again, just warm it again, no biggie.

  9. #9
    Elite ken Sass's Avatar
    Join Date
    Jul 2012
    Posts
    2,054
    Thanks
    1,182
    Thanked 565 Times in 334 Posts

    Re: Cloudy GEar :(

    watch the oven you can melt the rubber and contaminate your shit

  10. #10
    Elite LeanHerm's Avatar
    Join Date
    Apr 2012
    Posts
    6,426
    Thanks
    1,337
    Thanked 2,410 Times in 1,185 Posts

    Re: Cloudy GEar :(

    Yes I think fd said put it in an oven for 3 minutes at 350. Don't quote me on that

  11. #11
    Elite Cobra Strike's Avatar
    Join Date
    Apr 2012
    Location
    Smack Center
    Posts
    2,613
    Thanks
    998
    Thanked 1,661 Times in 705 Posts

    Re: Cloudy GEar :(

    shit...as long as there is no crystals in the shit I would just pin it cloudy...cloudy is not crashed..I pin tren a cloudy all the time..gel like or crystals in the oil is bad lol

  12. #12
    Elite. SFGiants's Avatar
    Join Date
    Apr 2012
    Location
    In A Vagina
    Posts
    6,433
    Thanks
    4,935
    Thanked 5,397 Times in 2,263 Posts

    Re: Cloudy GEar :(

    Originally Posted by Spongy View Post
    my guess is that it is starting to crash, pretty common this time of year, especially with test C. boil some water, remove from heat, stick vial in water for 20 min.
    Depends on who's making it I have seen Test C 300 hold up in the snow States of the Country also depends how it's store and temperature of room it's in.
    Knock Em Down and Keep Em Down!

  13. #13
    Member 3DRanger87's Avatar
    Join Date
    Oct 2012
    Posts
    61
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    Just warm it up brother, should be good to go. I had the same issue with my gear but it eventually crashed and turned into straight crystals.
    On a long enough timeline, the survival rate for everyone drops to zero.

  14. #14
    Elite Patriot1405's Avatar
    Join Date
    Jul 2012
    Posts
    582
    Thanks
    1,241
    Thanked 241 Times in 129 Posts

    Cloudy GEar :(

    I usually nuke a cup of water for 4 minutes. Then I drop the vial in for about 5, swirl and pin!!

  15. #15
    Senior Member Four1Thr33's Avatar
    Join Date
    May 2012
    Location
    Unknown
    Posts
    2,122
    Thanks
    53
    Thanked 53 Times in 38 Posts

    Re: Cloudy GEar :(

    It's safe as everyone else stated it just seems to be crashing
    Wolves don't loose sleepover opinions of sheep

  16. #16
    Elite. SFGiants's Avatar
    Join Date
    Apr 2012
    Location
    In A Vagina
    Posts
    6,433
    Thanks
    4,935
    Thanked 5,397 Times in 2,263 Posts

    Re: Cloudy GEar :(

    Clouding received should not be take as ok and safe.

    Clouding is also from bad filtering!

    Now Tren A sludge and swirls this is not clouding at all it's oxidization which is ok clouding isn't also I have never seen anything cloud then crash I have seen things cloud I have seen things crash but that are not the same. You don't cloud before a crash it just crashes into crystals from what I have seen.

    Clouding can also be from moister and this is removed by heat.

    Bad filtering will clear with heat but cloud right back up.

    Tren that goes through oxidization can be heated to clear up but will oxidize again to sludge bad swirls but still good.

    Bottom line if you didn't brew it and see it cloud during sterilization you have no clue if it's water or bad filtering.

    Clouding can only be judged as good or bad by nowing exactly way it's clouding not by a guess.
    Knock Em Down and Keep Em Down!

  17. #17
    Elite. SFGiants's Avatar
    Join Date
    Apr 2012
    Location
    In A Vagina
    Posts
    6,433
    Thanks
    4,935
    Thanked 5,397 Times in 2,263 Posts

    Re: Cloudy GEar :(

    God Damn it why can't we edit it? I make too many typo's!
    Knock Em Down and Keep Em Down!

  18. #18
    Senior Member
    Join Date
    Nov 2012
    Posts
    128
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Cloudy GEar :(

    Prob wont use it should i just through it in the trash SFgiants?

  19. #19
    Elite FreeBirdSam's Avatar
    Join Date
    Nov 2012
    Location
    Sooner State
    Posts
    782
    Thanks
    452
    Thanked 193 Times in 106 Posts

    Re: Cloudy GEar :(

    I have never had an issue with cloudiness in anything other than tren, but I do however always bake my UGL gear in the oven for about 20 minutes at 300F. I vent about every 5 minutes or so to relieve pressure. Leaving a needle in the rubber the entire time will cause a hole in the rubber and your vial will leak. You will then need to transfer the oil to a separate sterile vial or risk it being contaminated. Some rubbers are different and even venting every five minutes will cause them to leak. Always have sterile vials on hand just in case.

    -sam

  20. #20
    Senior Member Four1Thr33's Avatar
    Join Date
    May 2012
    Location
    Unknown
    Posts
    2,122
    Thanks
    53
    Thanked 53 Times in 38 Posts

    Re: Cloudy GEar :(

    Or^ just draw it all out with a 10cc syringe and transfer to steril vial threw a .22micron syring filter ... Only cost a few bux. I personally wouldn't toss it.
    Wolves don't loose sleepover opinions of sheep

Page 1 of 2 12 LastLast

Similar Threads

  1. cloudy tren
    By grizzldsealpoacher in forum Anabolic Steroids
    Replies: 14
    Last Post: 05-21-2016, 01:01 AM
  2. Cloudy testosterone Enanthate
    By tikib05 in forum Chemical Conversion and Homebrewing
    Replies: 16
    Last Post: 12-22-2014, 12:55 AM
  3. Cloudy Tren
    By italian1 in forum Anabolic Steroids
    Replies: 14
    Last Post: 05-23-2014, 07:53 PM
  4. My tren got cloudy
    By Mean Machine in forum Anabolic Steroids
    Replies: 12
    Last Post: 01-30-2014, 11:45 PM
  5. My masteron is cloudy; Can I still use it?
    By UltraAlmondy in forum Anabolic Steroids
    Replies: 13
    Last Post: 07-11-2013, 05:53 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •