Results 1 to 12 of 12
  1. #1
    Senior Member
    Join Date
    Jun 2012
    Posts
    637
    Thanks
    27
    Thanked 84 Times in 58 Posts

    converting raws into caps/ liquid oral?

    can someone pleaseeee make a thread on how to convert raw powders in to caps or liquid orals.
    preferably anavar,dbol,drol. I looked around and I seen too many different ways its mind boggling.

    id really appreciate it. thank youuuu!!!!!!

  2. #2
    Elite Azog's Avatar
    Join Date
    Jun 2012
    Posts
    2,968
    Thanks
    540
    Thanked 594 Times in 403 Posts
    Just put the powder in booze and shake. Seriously.

  3. #3
    Member
    Join Date
    Aug 2013
    Posts
    71
    Thanks
    3
    Thanked 0 Times in 0 Posts
    Anadrol:
    Highest concentration made - 50mg/ml
    Per 1 gram of Oxymetholone you will need:
    8.4 ml's of PEG 300
    10.5 ml's 190 Proof Grain Alcohol

    Anavar:
    Highest concentration made - 20mg/ml
    Per 1 gram of Oxandrolone powder you will need:
    9.8 ml's of PEG 300
    39.2 ml's of 190 Proof Grain Alcohol

    Armidex:
    Highest concentration made - 5mg/ml
    Per 1 gram of Anastrozole powder you will need:
    19.9 ml's PEG 300
    179.1 ml's of 190 Proof Grain Alcohol

    Clomid:
    Highest concentration made - 50mg/ml
    Per 1 gram of Clomiphene Citrate you will need:
    8.4 ml's of PEG 600
    10.5 ml's 190 Proof Grain Alcohol

    Dianabol:
    Highest concentration made - 50mg/ml
    Per 1 gram of Methandrostenolone powder you will need:
    19 ml's of 190 Proof Grain Alcohol
    No PEG needed. Follow the no PEG recipe.

    Femara:
    Highest concentration made - 5mg/ml
    Per 1 gram of letrozole powder you will need:
    19.9 ml's PEG 300
    179.1 ml's of 190 Proof Grain Alcohol

    Nolvadex:
    Highest concentration made - 20mg/ml
    Per 1 gram of Tamoxifen Citrate you will need:
    9.8 ml's of PEG 600
    39.2 ml's of 190 Proof Grain Alcohol

    Proviron:
    Highest concentration made - 50mg/ml
    Per 1 gram of Mesterolone you will need:
    8.4 ml's of PEG 300
    10.5 ml's 190 Proof Grain Alcohol

    Winstrol:
    Highest concentration made - 25 mg/ml
    Per 1 gram of Stanzolol you will need:
    7.8 ml's of PEG 300
    31.2 ml's of 190 Proof Grain Alcohol

    Solutions requiring PEG and 190 Proof Alcohol

    Step 1. Prepare a hot water bath. Boil water in microwave or on a pot. Once boiling starts remove from heat.

    Step 2. Place PEG and powder in beaker.

    Step 3. Place the beaker deep enough in to the water so that the hot water is level with the PEG and powder. Gently swirl or stir with a stir rod until solution is clear. Reheat water as needed.

    Step 4. Allow PEG to cool some. Then add in your 190 proof alcohol. You don't have to do this drop by drop but don't just dump it in. Pour it in slowly.

    Step 5. Stir or gently shake until mixed.



    For recipes that do not require PEG.

    1. Mix powder and 190 proof alcohol.

    2. Stir with stir rod or shake. Most powders that do not require PEG will disolve no problem. If heat is needed follow the instructions for heating powders that use PEG

  4. #4
    Senior Member
    Join Date
    Jun 2012
    Posts
    637
    Thanks
    27
    Thanked 84 Times in 58 Posts
    thanks brother. appreciated

  5. #5
    Senior Member Four1Thr33's Avatar
    Join Date
    May 2012
    Location
    Unknown
    Posts
    2,122
    Thanks
    53
    Thanked 53 Times in 38 Posts
    Bro I just use Ora plus and Ora sweet with orals
    Just basic suspensions
    Wolves don't loose sleepover opinions of sheep

  6. #6
    Senior Member IronCore's Avatar
    Join Date
    Sep 2012
    Posts
    116
    Thanks
    3
    Thanked 26 Times in 16 Posts
    the best thing to do is keep it simple... and PEG taste like shit...

    if you want to cap you need to know a few things... what is the desired dosage of each compound and what filler you want to use... then you need to know the weight of the filler...

    In the simplest of terms you can make "spoon" that accurately weighs the desired dose, then fill each cap with the hormone and then add the filler... pack tightly, and then weight about 10 caps to get a good finished cap weight... average that number and then subtract the gel cap weight...

    once you have the average total cap weight subtract the hormone weight and you will have the amount of filler per cap...

    then it is simple math from there...

    i.e.

    Cap dose = 50mg
    total cap weight - 801mg
    gel cap weight- 1mg
    filler weight = 801-50-1 = 750mg

    if you are going to make a batch of 50 then you math would be similar to this

    total hormone- 50*50mg= 2.5g
    total filler - 50*750mg=37.5g

    Mix hormone and filler WELL... then cap away...

    If this sounds too complicated you may not want to try to cap... it may look cheaper up front... but it can bee quite costly in the end... better to just buy some caps/tabs and be done with it.

  7. #7
    Senior Member
    Join Date
    Jun 2012
    Posts
    637
    Thanks
    27
    Thanked 84 Times in 58 Posts
    goos lookin ironcore. sounds good

  8. #8
    Elite Solid Snake's Avatar
    Join Date
    Apr 2012
    Posts
    165
    Thanks
    5
    Thanked 13 Times in 8 Posts
    I cap my own dbol and var. It took some practice but I finally got my formula figured out. Basically for 300 25mg caps you need 7.5g of raw powder. I mix that powder with 22.5g of jello. I mix those until I get a consistent color. That's what the jello is for, to make sure your raw is distributed as even as possibly. I then mix that with 125g of Creatine and then it's off to the capping machine. I try to use red jello so that my final product is a very light shade of pink.

    They may not be exactly 25mg but it works for me. I figure it averages out.

  9. #9
    Elite #TheMatrix's Avatar
    Join Date
    Dec 2012
    Location
    Suburbia
    Posts
    2,529
    Thanks
    421
    Thanked 719 Times in 498 Posts
    Originally Posted by Solid Snake View Post
    I cap my own dbol and var. It took some practice but I finally got my formula figured out. Basically for 300 25mg caps you need 7.5g of raw powder. I mix that powder with 22.5g of jello. I mix those until I get a consistent color. That's what the jello is for, to make sure your raw is distributed as even as possibly. I then mix that with 125g of Creatine and then it's off to the capping machine. I try to use red jello so that my final product is a very light shade of pink.

    They may not be exactly 25mg but it works for me. I figure it averages out.
    this sounds like nice info.....


    this should help

  10. #10
    Member
    Join Date
    Sep 2014
    Location
    Tucson, AZ
    Posts
    24
    Thanks
    0
    Thanked 4 Times in 4 Posts
    That is awesome, thanks for the info.

  11. #11
    Member
    Join Date
    Aug 2016
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts
    What size caps were you using

  12. #12
    Member
    Join Date
    Aug 2016
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts
    What size capsules are you using

Similar Threads

  1. Converting Research Chem Powders To Liquid
    By RowdyBrad in forum Chemical Conversion and Homebrewing
    Replies: 12
    Last Post: 02-03-2015, 09:23 AM
  2. Does liquid clomid & liquid novadex come up on urine test.
    By BeastKiller in forum General Chat & Conversation
    Replies: 10
    Last Post: 11-22-2014, 07:36 AM
  3. Converting Boldenone Undecyclenate.
    By Bicepticon in forum Chemical Conversion and Homebrewing
    Replies: 15
    Last Post: 02-16-2013, 12:39 AM
  4. Aromasin liquid from caps
    By Capt'n Ron in forum Chemical Conversion and Homebrewing
    Replies: 3
    Last Post: 10-03-2012, 01:01 PM
  5. Clomid caps to liquid?
    By 0tj0 in forum Post Cycle Therapy
    Replies: 4
    Last Post: 09-05-2012, 07:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •