- Joined
- Dec 24, 2017
- Messages
- 48
- Reaction score
- 24
- Points
- 3
I am going to construct a small jig to fit a 10ml(or whatever size) syringe, with plunger handle extending into plastic pipe.
Plastic pipe will be secured to holder.
I will have a rod through the pipe that makes contact with plunger thumb top in tube.
I will have a flat flange at top of rod where I can secure a 5-10lbs weight on top.
This will apply slow constant pressure to plunger. Then you can get a workout in while it filters.
I use bottle top filters as well.
However, if running test blends, small amounts... can test how it pins/pip.
If your dead set on syringe filters, would make it easy.
Plastic pipe will be secured to holder.
I will have a rod through the pipe that makes contact with plunger thumb top in tube.
I will have a flat flange at top of rod where I can secure a 5-10lbs weight on top.
This will apply slow constant pressure to plunger. Then you can get a workout in while it filters.
I use bottle top filters as well.
However, if running test blends, small amounts... can test how it pins/pip.
If your dead set on syringe filters, would make it easy.