HDH
Elite
- Joined
- Oct 27, 2012
- Messages
- 1,118
- Reaction score
- 447
- Points
- 83
Hey guys/gals, this is going to be a simple thread on filling slin pins with oil. It doesn't matter if the oil is thick, thin, heated or not heated.
After you put the pin in the vial and push the air in with the plunger, pull the plunger almost all the way out until it locks. If you pull it out too far, you will lose the seal so make sure you stop or you will have to replunge.
After the plunger is locked, open up a drawer just a little, put it in and walk away.
If you have more than one.
Easy, easy.
After you put the pin in the vial and push the air in with the plunger, pull the plunger almost all the way out until it locks. If you pull it out too far, you will lose the seal so make sure you stop or you will have to replunge.
After the plunger is locked, open up a drawer just a little, put it in and walk away.
If you have more than one.
Easy, easy.
Last edited: